Servicing
Gate maintenance essentials
3 min read
Why maintenance matters for automated gates
An automated gate is a piece of powered machinery installed at a boundary people and vehicles pass through regularly. Moving parts wear, safety devices can drift out of calibration, and control electronics benefit from periodic checking — planned maintenance catches these before they become a breakdown or, more importantly, a safety issue.
What a maintenance visit typically covers
Checking and testing safety devices (photocells, safety edges, force limiting), inspecting hinges, tracks, rollers and fixings for wear, testing manual release and backup power, and checking the control system and access credentials are functioning as expected.
Signs a gate needs attention sooner
Slower or jerky movement, unusual noise during operation, a gate that no longer fully closes or reverses unexpectedly, or an intercom or keypad that's become unreliable are all reasons to book a visit rather than wait for the next scheduled service.
How often should an automatic gate be serviced?
For most private driveways, every six months to a year is typical, depending on how often the gate runs and how exposed it is. A busy shared entrance or commercial gate wears by the number of cycles rather than the calendar, so it usually needs visits more often. Coastal sites, underground operators and solid gates on exposed plots also benefit from a shorter interval.
What happens when the power goes off?
Systems with battery backup keep working for a limited number of cycles; how many depends on the battery's age and condition, which is why batteries are tested under load at each service. Every automatic gate also has a manual release — usually a key-operated lever or cover on the operator — that disengages the motor so the gate can be moved by hand. Make sure you know where yours is and that the key is kept somewhere you can find in the dark.
Checks an owner can safely make
Keep photocell lenses clean and free of cobwebs and plant growth, clear leaves and stones from sliding gate tracks and the run-back area, and replace remote batteries when range starts to drop. Watch a full open-and-close cycle now and then and note anything new.
Don't adjust force settings, bypass a photocell or wedge a gate open against its motor. If a safety device is stopping the gate, it is usually telling you something — isolate the power and book a visit.
